One one of the Fakebook groups for the H10, one H10 owner used a couple 2 or 3mm spacers on the aluminum posts and a few longer screws to push the spur side out a few mm so he could shoehorn in a HW3300kv AXE Motor. He also used a 4 or 5mm spacker on the bottom mount to tilt it up a bit. runs no spur cover and he used a flat cheap slipper eliminator on the shaft to allow the room for the forward shift don't he spur shaft.
He said he's been running it for a few months with no problems, so there are some ways to shoehorn in these slightly longer 550 BL Cans.
I almost grabbed a 3300 combo, but opted for the 2800kv combo as I didn't really want to have to mod much being this is my full on 1st Vanquish kit/build/rig.
He said he's been running it for a few months with no problems, so there are some ways to shoehorn in these slightly longer 550 BL Cans.
I almost grabbed a 3300 combo, but opted for the 2800kv combo as I didn't really want to have to mod much being this is my full on 1st Vanquish kit/build/rig.