Thoughts on HR vs incision spool lockers

[Spence]

Hi guys my ax10 deadbolt is pretty built rn, it's got a lot of upgrades, and a top tip I found out for the stock axle housings if the c hub screws strip out the plastic, put some hot glue on the screw and jam it in there and twist it a little and let it dry it holds up until the next time you remove the screws. But anywho, the only stuff that is stock left is the axle housings rear lockouts and the stock axial aluminum bevel gears and the plastic housing lockers. I am exploring the HR spool vs the incision one, the HR Is $2 or so less... Since I'm cheap, would the stock used bevel gears fit the spools? I feel like the lockers will fall apart before the gears will, the stock locker is ok but it involves plastic in the driveline...


Thanks
-Spence

 

[rob5059]

I run the HR spools or FI spools from locked up RC. Never had a problem with them. The stock gears will fit.

 

[Ditchrat]

Hi guys my ax10 deadbolt is pretty built rn, it's got a lot of upgrades, and a top tip I found out for the stock axle housings if the c hub screws strip out the plastic, put some hot glue on the screw and jam it in there and twist it a little and let it dry it holds up until the next time you remove the screws. But anywho, the only stuff that is stock left is the axle housings rear lockouts and the stock axial aluminum bevel gears and the plastic housing lockers. I am exploring the HR spool vs the incision one, the HR Is $2 or so less... Since I'm cheap, would the stock used bevel gears fit the spools? I feel like the lockers will fall apart before the gears will, the stock locker is ok but it involves plastic in the driveline...


Thanks
-Spence

If you are cheap, nothing wrong with that, you can get a TFL locker for $6.90 each, from their T-10 pro. I have a couple, the threads holes line up, and are clean. Can't say they are a tight fit, but nor can I say they are sloppy.
So far I have sheared a pair of CVD's but no issues on the locker.

 

[jason1973]

if it fit the budget get the grip fab locker with the set screws.

super nice i think you can get 2 for $50 bucks.

http://www.rccrawler.com/forum/axles-trannys-t-case/432907-gripfab-grip-lok-locker.html

 

[mikemcE]

I like the incision locker. Feels like a well made piece.

All I run thanks to Harleys recomendation

Trouble free"thumbsup"

 

[ferp420]

I have a hr spool and a incision spool both have the same amount of slop the incision has some nifty machine work that i cant quite figure out what its for i also have the fi spools and the dead lock spools i realy dont see a differance in how they work however the fi and deadloc spools are thicker and th3 deadlocs are only like $12 so there my new go to locker im not noticing any differance in function or performance however the fi and d3adloc are heavyer so better on the front and the hr and incision spools are lighter still stronge enuff to do the job but i think would be better on the rear i dont have any first hand exsperiance with the other brands or styles