-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Weekend Warrior
- Thread starter lonleycreeper
- Start date
lonleycreeper
I wanna be Dave
lol I just pulled it off the shelf, but I have no real updates, as I need to invest some funds to get the project going again. I should be able to mount a 3gear trans in between the frame rails, and I want to bring the wheelbase in a fraction of an inch...
I need firmer springs too, as the current springs are way too soft. Drive shafts, Carrier bearing for the rear...
I need firmer springs too, as the current springs are way too soft. Drive shafts, Carrier bearing for the rear...
lonleycreeper
I wanna be Dave
An Idea o the size...
Last edited:
lonleycreeper
I wanna be Dave
No updates, I am not happy with the chassis, I will be rebuilding it when I pick up more materials.
i know your trying to keep the wheels under the wheel wells but the yeti is practicly a bolt on you just need longer rear links and it performs realy good
Any update?
I'm curious about the driveshafts, especially the rear :mrgreen: "thumbsup"
I'm curious about the driveshafts, especially the rear :mrgreen: "thumbsup"
personaly i have one rig running a gds shaft 162mm i think i would have to check on the langth to make sure the other is running wildboar hd8 shaft with a extended center spline section living on 4s
my new raptor build is most likely gona run the wild boars too there just realy good shafts for a stock part
Last edited:
Similar threads
