Hi folks, I received my first RC4WD truck this week. I picked up the red RTR 4Runner. It's a beautiful truck with lots of great features.
However I'm struggling to mount the body to the chassis. The body will not sit low enough to line up with the screw holes on the mounts. I forced it down to get it screwed in but there was noticable warp in the sides and the passenger door wasnt as "snappy" as it usually is. I don't like the amount of pressure on the body - I expect it may fail over time.
I can't see anything obvious that would be stopping it from sitting low enough - perhaps the interior or engine bay. The issue was happening before I put the fenders on too.
Is it usually a tight fit like this?
Here's a pic to illustrate the gap...you can see that it lines up perfectly - just too high
However I'm struggling to mount the body to the chassis. The body will not sit low enough to line up with the screw holes on the mounts. I forced it down to get it screwed in but there was noticable warp in the sides and the passenger door wasnt as "snappy" as it usually is. I don't like the amount of pressure on the body - I expect it may fail over time.
I can't see anything obvious that would be stopping it from sitting low enough - perhaps the interior or engine bay. The issue was happening before I put the fenders on too.
Is it usually a tight fit like this?
Here's a pic to illustrate the gap...you can see that it lines up perfectly - just too high
