youngblood
RCC Addict
I r dum.
What do digital servos and programing your tx have to do with keeping your 5b from running away?
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
The HPI Baja 5T is HUGE!! *PICS*
- Thread starter MDcrawler72
- Start date
I r dum.
What do digital servos and programing your tx have to do with keeping your 5b from running away?
champ7times
Pebble Pounder
when it looses signal or batteries run low the servos go to neutral car goes to idle
from the instruction manual
fail safe function
this function moves the steering,throttle and 3 servos to a preset position when the receiver cannot receive the signal from the transmitter for some reason.when the servo operation position is not set,this function operates so that the servos remain in the position they were in immediately before reception was lost. when the signal from the transmitter can be received again, this function automatically resets.
battery fail safe function
when the receiver battery voltage drops to a certain voltage or less,this function moves the throttle servo to the position set by the fail safe function. when the voltage recovers,this function automatically resets.
from the instruction manual
fail safe function
this function moves the steering,throttle and 3 servos to a preset position when the receiver cannot receive the signal from the transmitter for some reason.when the servo operation position is not set,this function operates so that the servos remain in the position they were in immediately before reception was lost. when the signal from the transmitter can be received again, this function automatically resets.
battery fail safe function
when the receiver battery voltage drops to a certain voltage or less,this function moves the throttle servo to the position set by the fail safe function. when the voltage recovers,this function automatically resets.
Last edited:
champ7times
Pebble Pounder
man running these sure is fun but cleaning them is a pain in the mother f$#@ing a@#
youngblood
RCC Addict
Im still having a hard time wraping my little brain around this...
How does programming the controller help you if your battery in the car drains too low?
How does programming the controller help you if your battery in the car drains too low?
champ7times
Pebble Pounder
the 3pk you can set your servos to go to a position that you preset.say this you are running your 5b ss :lol:when the receiver loses signal. i guessing on this part but the receiver monitors the signal or battery strength when it doesn't get the right signal or notices weak voltage coming from pack it goes into fail safe mode.when that guy ran me over with his red cat and i slammed my controller on the ground the receiver lost signal and went into fail safe mode.which i all ready preset the servos the steering servo went neutral and the throttle servo applied the brakes. and that stopped my car from rocketing across the field into Montana:lol: i hope that helps
