dpdsurf
I wanna be Dave
OFFICIAL SIGNUP THREAD HERE ON RCC!
Location: Folsom Reservoir, Dotons Point
Date: February 7, 2010
2.2 Class
1.9 Class
UPDDATE: A 12 and under Rangers Class will be offered - Thanks Racer-X "thumbsup"
Time: Tech - 8:30
Comp - 9:00
Series Members FREE / Non-Members $5.00
2.2 Class is Limited to 53 drivers
1.9 Class is Limited to 209 drivers
2010 USRCCA Rules will be observed
Please note an important change to the wheelbase measuring and tech procedure.
2.3.1 - Vehicle wheelbase is limited to a maximum of 12.5 inches.
6.4 - Wheelbase: is measured from center of axle nut to center of axle nut. The vehicle should be set down on a flat surface by the driver. The front wheel on the side that is being checked, must be pointing straight forward. At that time, the driver will then cycle the suspension through it's complete extension and compression range while the judge measures the vehicle's maximum wheelbase. At any point the vehicle's wheelbase cannot extend beyond the maximum limit of it?s class. All the above procedures must be duplicated on the opposite side. Note: If the vehicles wheelbase is affected by radio control it must be cycled or activated during tech inspection.
Bodied vehicles will be teched with the body on.
Comp site location and turn-off:
http://maps.google.com/maps?f=q&hl=en&geocode=&time=&date=&ttype=&q=38.76306,-121.130185&ie=UTF8&z=13&iwloc=addr&om=1
Click the following link for comp format and additional informationhttp://www.nor-calrcrc.com/forum/showthread.php?t=361
Location: Folsom Reservoir, Dotons Point
Date: February 7, 2010
2.2 Class
1.9 Class
UPDDATE: A 12 and under Rangers Class will be offered - Thanks Racer-X "thumbsup"
Time: Tech - 8:30
Comp - 9:00
Series Members FREE / Non-Members $5.00
2.2 Class is Limited to 53 drivers
1.9 Class is Limited to 209 drivers
2010 USRCCA Rules will be observed
Please note an important change to the wheelbase measuring and tech procedure.
2.3.1 - Vehicle wheelbase is limited to a maximum of 12.5 inches.
6.4 - Wheelbase: is measured from center of axle nut to center of axle nut. The vehicle should be set down on a flat surface by the driver. The front wheel on the side that is being checked, must be pointing straight forward. At that time, the driver will then cycle the suspension through it's complete extension and compression range while the judge measures the vehicle's maximum wheelbase. At any point the vehicle's wheelbase cannot extend beyond the maximum limit of it?s class. All the above procedures must be duplicated on the opposite side. Note: If the vehicles wheelbase is affected by radio control it must be cycled or activated during tech inspection.
Bodied vehicles will be teched with the body on.
Comp site location and turn-off:
http://maps.google.com/maps?f=q&hl=en&geocode=&time=&date=&ttype=&q=38.76306,-121.130185&ie=UTF8&z=13&iwloc=addr&om=1
Click the following link for comp format and additional informationhttp://www.nor-calrcrc.com/forum/showthread.php?t=361
Last edited: