Hulksta Riddler with a dash of Dlux

[filotr14lsdude]

Thanks for that....very much...answered several questions for me "thumbsup"
Was thinking of no oil at all...just an internal spring. A fairly stiff spring at that.
You must have a limiter inside...and it runs compressed most of the time correct? So it can't be too stiff....have to play with that I suspect.
I have Egressor shocks for the main 4 ....been looking around for scx10 shocks/rebuild kit...can't believe I got rid of them and never kept a set in all the scx10 builds I have. Hard to find guts for these...about ready to post up a wanted thread for used stuff.
Thanks for sharing your info mate "thumbsup"

The spring is the limiter in the shock. That's why a shorter one Is better, to long and it gets coil bound and feels terrible when moving.

 

[Postclanker]

So, the spring goes underneath the piston...between the piston and the bottom of the shock body instead of between the cap and the piston? I don't see how else the spring would act as a limiter....

Or haven't I had enough coffee yet....

Curious to know what spring you used also...

Thanks for all the dumb questions.....

 

[Postclanker]

Nevermind you want the traxxas rebuild kit for the big bores TRA7062
Then all you need is the piston, shaft and shock caps from an SCX10 shock Or use the rcbros shock cap

So I finally found that Traxxas part # 7062. I have a tra2326 and I think those parts (o-rings and spacers) are the same size....but what do I know.

Thanks for your help Highlucks "thumbsup"

 

[noname0383]

So, the spring goes underneath the piston...between the piston and the bottom of the shock body instead of between the cap and the piston? I don't see how else the spring would act as a limiter....

Curious to know what spring you used also...

Thanks for all the dumb questions.....

Same questions here:roll:

For now, with the new update 2-shocks, i used a scx 90mm shocks with a ''Bic pen'' spring between the piston and the bottom of the shock body...
as for the other one, not sure what oil i should put in... Or diff oil...?

And How did u manage to obtained such a droop setup?
I'm using scx 90mm shocks with Losi mrc silver soft spring, dlux no preoload retainer... but i'm not as droop as yours...
Shocks lenght?
Brand?
What springs?
Limiter?
etc...

thx

Mine: http://www.rccrawler.com/forum/rc4wd-bully/544617-hulksta-riddler-2.html#post5327491