• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

1:8 DUKW- Scratch build

I built the t-case as well, using some gears from an HG-P602 MRAP, and some purchased gears. Stout. 1.87:1 ratio.

1 in, 3-out t-case:
483831665_10228241283923944_7048317595805454330_n.jpg


Don't count on 3D prints to be super accurate. I milled the housings to accept bearings and set the gear spacing.
484094580_10228241272163650_4750105751794436940_n.jpg


These bushings were replaced with ball bearings.
484049421_10228241267803541_2972649021531897509_n.jpg
 
Back
Top