SSD RC SCX10 III Parts

[SSD]

We now have a few parts for the SCX10 III available:

Brass diff cover

HD Brass Diff Cover for SCX10 III


Brass knuckles

Brass Knuckles for SCX10 III / Capra


Overdrive steel portal gears

Overdrive Portal Gears for SCX10 III / Capra


Steel portal gears

Steel Portal Gears for SCX10 III / Capra


Brass portal covers

Brass Portal Cover for SCX10 III / Capra


Hex that allow SSD aluminum wheels to clear the portals

Aluminum 6mm Hex Set for SCX10 III / Capra


A full list of compatible SSD parts: PARTS FOR SCX10 III

More are in the works....

 

[TK421]

WOW!! Sexy stuff, well done!

Lou

 

[Topher Builds]

Brass knuckle and portal cover combo is killer!

Any axle housings in the works by chance?

 

[hezzdown]

Always been a big fan of SSD products, all my rigs have a good dose of the parts. I've got the diff covers on the way, very nice! Looking at the overdrive gear set, but I'm on the fence. 25% is pretty aggressive.

Sent from my moto z4 using Tapatalk

 

[smog]

Brass knuckle and portal cover combo is killer!

?

100%


...and the finish on these pieces"thumbsup"

 

[bigcanoe]

Sharp stuff!

 

[2manytickets]

I noticed when I put the overdrive gear in the front axle. The transmission did not like it. There was grinding noises under a load. Anyone else run into thus problem

 

[Crush]

I noticed when I put the overdrive gear in the front axle. The transmission did not like it. There was grinding noises under a load. Anyone else run into thus problem

im running the overdrive ring and pinion in the scx10 iii Gladiator and have not had that problem.

 

[Topher Builds]

I noticed when I put the overdrive gear in the front axle. The transmission did not like it. There was grinding noises under a load. Anyone else run into thus problem

Try the stock pinion and OD ring gear, might get a little better mesh.

 

[89redranger]

Where are the 10.3 straight axle compatible knuckles, c-hubs, and rear weights? ;-);-);-)

 

[TK421]

What he said ^

Lou

 

[FordSpeed]

Where are the 10.3 straight axle compatible knuckles, c-hubs, and rear weights? ;-);-);-)

I would try the SCX II section. I'm sure someone will correct me if I'm wrong, but I believe the only difference between the scxII and scxIII straight axles is the non-centered pumpkin, otherwise everything else should work.


PARTS FOR SCX10 II

 

[TK421]

A few others have already tried, the 10.2 knuckles don’t line up...


Lou

 

[89redranger]

I would try the SCX II section. I'm sure someone will correct me if I'm wrong, but I believe the only difference between the scxII and scxIII straight axles is the non-centered pumpkin, otherwise everything else should work.


PARTS FOR SCX10 II

The outer stub shafts on the 10.3 universals are longer by about 1mm. Which makes knuckles incompatible.

Sent from my SM-S111DL using Tapatalk

 

[FordSpeed]

Didn't know that. Thanks guys!