ProLine Jeep Wrangler with ProLine Floor Pan / Interior?

[Chachi_RC]

I was just wondering, and searched with no luck, but has anyone used the ProLine Jeep Wrangler Rubicon body (#3322-00) with the ProLine PL-C Floor Pan (#3339-00) or the ProLine PL-C Interior (#3337-00) or both? I know the floor pan and interior are designed for the Comanche, but I was just thinking of trying to make it work on an SCX10 Honcho. Any help or thoughts would be appreciated. Thanks!
http://prolineracing.com/rock-crawling-bodies

 

[constantmotion]

It's actually designed for the the Cherokee

 

[Chachi_RC]

It's actually designed for the the Cherokee

Correct, my bad. Yes, the Cherokee. But the question remains....will it work with some modification on the Wrangler. I am tempted to just give it a shot, but thought I would see if anyone has done it first. Research, research, research! ;-)

 

[Szczerba]

Well, I just put one under my 11.25" wheelbase blazer, without much trimming.

Looks like the Wrangler is 11.8" WB. And the Cherokee is 11.8" wb. And the floorpan is 11.4". I think you will be fine with some minor trimming.

I just bought it cause I knew I could trim it to make it fit just about anything 1/10 scale. My 11.25" is cutting it close on the body covering up the wheel wells. But it works.

Some pictures of my floor'd blazer here.
http://www.rccrawler.com/forum/showthread.php?t=267528

 

[Chachi_RC]

Cool, and thanks for the info! The good thing is that make a 11.4" and 12.3" floor pan, so one to fit each version of the SXC10. Thanks again for the info and the pics too! I love the look of your Blazer too! Good work!