Live Venom Creeper build today!

[Syd]

X2"thumbsup"

brass monkey = team Jinglenutz team song lol

$2 for Jinglenutz banner

 

[CRAWLINGAROUND]

Nope its not on there so maybe a zip tie will be ok, lol :lol:

 

[Syd]

Welsome To Rcc, Doing things Ass Backwards One Crawler At A Time;-)

The dollar sign on the roof is ass backwards:lol:

 

[ColquittCustom405]

So far what can we toss out on this kit?

 

[ZUKMAN]

Is the axle width close enough to the axial that you could use the Venom on the front and the axial in the rear?

Gear ratios close on both?

Too Short"thumbsup"

 

[CBR]

Oh hey,
Upper right link (driver right) needs the cable stay assembled on it before you finish it up and put the axle to the chassis. Cant tell if it its on there from the video.

Did Kris see this?

 

[emaxxjeremy]

do u need my address to send it to?

 

[Syd]

I'm excited to see it! Good Job with the Live Feed today guys! "thumbsup"

 

[CRAWLINGAROUND]

Oh, my bad, I see you installed the servo on the front left, usually because of the cable route its better to install on the right. Also the cable length will be to long. Should still work ok but its better the other way.

 

[cartronicshn]

Not sure if this has been discussed earlier, any shims for the ring & pinion included, or there is no noticeable play?

 

[ColquittCustom405]

Too Short and BB are dead even. Too SHort is forever saying this is his last album. Dr.Dre works for everyone.


Whe nyou're done can you post the axial and Venom next to each other.3:1? what pinon?

 

[CRAWLINGAROUND]

Diff ratio is 3:1
The gear table is in the manual

 

[thevulgarcowboy]

what size are the trans and axle inputs and outputs?

 

[Syd]

Venom; Great Job On The Creeper!"thumbsup"

 

[701 Technique]

Oh, my bad, I see you installed the servo on the front left, usually because of the cable route its better to install on the right. Also the cable length will be to long. Should still work ok but its better the other way.

Is Venom going to sell a Creeper axle parts set?

 

[CRAWLINGAROUND]

We have two spur gears as option parts also.

Ok cool, yeah left shock is in the way. Front right, correct. "thumbsup"

 

[CRAWLINGAROUND]

what size are the trans and axle inputs and outputs?

5mm

 

[cartronicshn]

Thanks for the heads up guys"thumbsup"

 

[thevulgarcowboy]

i wounder if punisher shaft would work? with the creeper

 

[CRAWLINGAROUND]

No axle part sets planned but the parts are available and inexpensive to put together your own kit. Manual is online to find the parts list.