• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

KCRC - Kansas City Remote Crawlers -

Decent enough to play around at, but like Jerry said, 9 courses would be a bit of a challenge.

Jerry did you walk the whole west side? As we headed out....thier is big section of rock on that westside, probally closer to the sk8 and tennis courts then the indian point.


Does have a nice view.....
 

Attachments

  • PVP1.JPG
    PVP1.JPG
    67.9 KB · Views: 171
I'm gonna author up all of last seasons videos on DVD for display in Hobby Town or any hobby shop if no one has any issues with it. Figured it might generate some interest for the club. Anyone have any objection?

I can burn up copies for anyone who would like one as well.
 
so, I went 1.5's on the scaler guys. I will post pics tomorrow. Also I have concocted a devious plan for my 2.2. :twisted::twisted::twisted:
 
I bought this out of the classifieds, "Ax10 roller with r2j double tri skid and his lower links. Needs trans work. Stock axles" It also comes with a set of eritex derlin comp fatties. I've been going to start a build thread aslo but wondered if these are the rules I should follow?
Here are the Sportsman vehicle specs straight from the 2011 rules:


2.5 –​
Sportsman Class (Optional):
2.5.1 - Vehicle wheelbase is limited to a maximum of 12.5 inches.
2.5.2 - Vehicle track width is limited to a maximum of 12.5 inches. This is determined by measuring
the bottom of the outer most edge of the front and rear tires while the vehicle is sitting on level ground.

2.5.3 - Vehicle is limited to 2.2 inch wheels/rims or smaller at the bead surface. Wheels may be modified, provided
that the tire bead surface does not exceed 2.2 inches in diameter. With a tire mounted, no exterior component of the
wheel, including but not limited to, the bead lock ring shall exceed 2.55". Tires may be modified from other sized tires
using only a pliable rubber, but must not exceed a total uncompressed outer diameter of 6 inches.

2.5.4 - Vehicles are limited to 2-wheel steering only.
2.5.5 – The body and Bodiless vehicles same as Class 2 vehicle –2.2 (See Sec. 2.3.5 & 2.3.6)
2.5.6 - Vehicles are limited to the use of 2 radio channels (one for steering & one for throttle) only. Neither channel
can be used to perform more than one function. Radio systems with more than 2 channels are allowed, but only 2
channels may be used to control the vehicle.

2.5.7 - Vehicles are limited to 1 ESC & 1 servo only.
2.5.8 - (OPTIONAL) Vehicles are limited to 1 motor powering both of the axles.
 
460e39da-76c7-7b46.jpg


stupid smart phone
 
Back
Top