Chip's Hot Rod AMC Pacer

[chip cross]

Specs:

Hand made chassis
New Mamba Max Pro
9000 KV motor
4000 maH 2S lipo
Hitec 5625 MG servo
Tamiya 1/14 scale big rig axle with full bearings
Pede wheels
Panther tires on the rear and some old 2.0 Pro-Line tires on the front
Ax-10 trans
Futaba 2.4 RX

This should be a fun build and wild to drive.

 

[jeepcj578]

it will never work:roll:

 

[62PYRO]

For being so ugly,it's cool.:mrgreen:
You should enter it in the speed shootout."thumbsup"

 

[chip cross]

For being so ugly,it's cool.:mrgreen:
You should enter it in the speed shootout."thumbsup"

I guess I will play along. "thumbsup"

 

[chip cross]

it will never work:roll:

I hate you.

 

[rockrawler]

Very cool "thumbsup" is your driver wayne or garth? :mrgreen:

 

[STANG KILLA SS]

been wondering when you were gonna enter a vehicle

 

[jeepjames87]

I am Building the same rig, Does the rear axle fit nice under the body, Where did you buy it, Thanks

 

[youngblood]

Makes me want a 1:1 pacer with a blown 401. :twisted:

 

[chip cross]

I am Building the same rig, Does the rear axle fit nice under the body, Where did you buy it, Thanks

It fits very well and I picked it up on Fleabay.

 

[chip cross]

been wondering when you were gonna enter a vehicle

I have been trying to heal up from surgery.

 

[chip cross]

I am trying to build this thing cheap as possible. I am building the chassis by hand with a hacksaw and a file. So far the only only money i have spent was for the body,axle, and two Panther racing slicks for the rear. I had everything else in my junk box.

Here is the ghetto front steering, it seems like it is going to work just fine. :|

Depending on how much the body drags the ground I may lower down the body some more.

 

[vonclod]

very cool, gonna be a handfull"thumbsup" i like it:twisted:

 

[chip cross]

very cool, gonna be a handfull"thumbsup" i like it:twisted:

Thank you sir. The Castle Creations 9000 KV motor on 2S Lipo will turn somewhere around 75K RPM. So yes, I will be backing down the EPA on the throttle channel to keep this thing on the ground. If I can get it to hook up and drive straight it should haul butt.

 

[jeepjames87]

Like what you did for the front end, how are you mounting the rear end?

 

[looneybin]

i see death in that pacers future."thumbsup"

 

[roscoeisthecool]

yup

i see death in that pacers future."thumbsup"

very short life 1 curb its done8)

 

[Drey]

That thing needs some wheelie bars sticking out the back to complete the look. Cool build!

 

[brianw]

That thing needs some wheelie bars sticking out the back to complete the look. Cool build!

I second the wheelie bars!