****best servo fpr mt****

[trevely15]

Hey guys

Whats the best servo for a 1/8 scale monster truck. The brand is thundertiger mt4 g3.
The truck has really big wheels and tires and i was looking around for a new servo and i would really like to have a servo that has fairly quick speed and loads of tourqe. My prics rang is $100

 

[crawler nut]

there is a thread for these questions. do a bit of searching in this section. as for the servo you can get a high tec 7980 from servo city for $120. little over the $100 mark but you will be very happy with it.

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-7.4 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-7.4 Volts
Operating Temperature Range: -20 to +60 Degree C (-68F to +140F)
Operating Speed (6.0V): 0.21 sec/60° at no load
Operating Speed (7.4V): 0.17 sec/60° at no load
Stall Torque (6.0V): 500oz/in. (36kg.cm)
Stall Torque (7.4V): 611oz/in. (44kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (6.0V): N/A (Testing Now)
Current Drain (4.8V): N/A (Testing Now)
Current Drain (6.0V): N/A (Testing Now)
Dead Band Width: 1usec
Motor Type: Coreless Carbon Brush
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Dual Ball Bearing MR106
Gear Type: Titanium Gears
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.72" x 0.88"x 1.57" (43.8 x 22.4 x 40mm)
Weight: 2.76oz (78.2g)