RS10runner
Newbie
I am a beginner and I rolled my RS10 Rockslide down a hill and now the steering won't work. Can anyone think of why this might be? I already replaced the rear servo because those wheels stick at full lock when it tries to turn.
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Steering problems
- Thread starter RS10runner
- Start date
Pat M
Quarry Creeper
? servo is broken, ? servo wire - plug a good working servo into the receiver port and test
RS10runner
Newbie
I replaced the servo with a new waterproof one and it still does not work. it is 4ws
RS10runner
Newbie
It does it with just the back wheels and they will turn full lock even when the steering for them is not engaged.
zero your trims on the remote.
remove the steering horn
test the servo
front servo should be in channel 1
ESC channel 2
Rear servo channel 3
most likely though when it roll it tweeked the horn and it is now trying to center off center. you may have to replace the horn.
remove the steering horn
test the servo
front servo should be in channel 1
ESC channel 2
Rear servo channel 3
most likely though when it roll it tweeked the horn and it is now trying to center off center. you may have to replace the horn.
