RC4wd new Warn winch problems

[Awesome-Sauce RC]

My controller has two 3 position switchs on it. Just don't know winch one of the hey ok controllers will work.

if you plug a servo into a spare channel and verify that the 3 position switch does indeed give you 3 different positions with the servo then you get the 3p winch controller from heyok, what radio are you using?


tony

 

[heyok]

My controller has two 3 position switchs on it. Just don't know winch one of the hey ok controllers will work.

Hi,
I'm on holiday until the 26th. Send me a pm after I get back and I will help.
Thanks,
Al

 

[diffman33]

I'm using the rc4wd 4 channel remote with 4 channel receiver. I have a bulldog winch I have tried out both of the channels on and they work the way they should. But the winch does the creep thing.

 

[heyok]

I'm using the rc4wd 4 channel remote with 4 channel receiver. I have a bulldog winch I have tried out both of the channels on and they work the way they should. But the winch does the creep thing.

This video was made for my winch controllers, but it might help you understand if there is anything you can do to make your winch work better:
Winch controller setup - YouTube

 

[KMS]

Two KMS winches and two HeyOk 4 amp relay controllers. Works killer"thumbsup"

Enough winch there to straighten out the frame rails...LOL "thumbsup"

 

[diffman33]

My controller is a rc4wd 4 channel. The 3 and 4 channels are 3 position with no epa adjustment. U have to buy a separate epa device from rc4wd. I am looking to get 2 of the new rc4wd warn wired winches. But have read they still have the problems the old bulldog winches had. Witch is the line will unravel or go in real slow. So I was going to order the winches with 2 of your controllers instead of the rc4wd controllers. Was just wondering witch ones I would need. I'm pretty sure I need the one that says for 3 position switchs.

 

[heyok]

My controller is a rc4wd 4 channel. The 3 and 4 channels are 3 position with no epa adjustment. U have to buy a separate epa device from rc4wd. I am looking to get 2 of the new rc4wd warn wired winches. But have read they still have the problems the old bulldog winches had. Witch is the line will unravel or go in real slow. So I was going to order the winches with 2 of your controllers instead of the rc4wd controllers. Was just wondering witch ones I would need. I'm pretty sure I need the one that says for 3 position switchs.

Yes, the three position ones are what you would need.
Either get this type:
http://www.rccrawler.com/forum/vend...ler-using-3-position-transmitter-channel.html
It will work at a maximum of six volts from the receiver and send that power to the winch.

Or, use this:
http://www.rccrawler.com/forum/vend...elay-output-winch-controller.html#post4754752
It can send full battery voltage to the winch. Be sure to read at least the first post in the thread about receiver voltages.

 

[diffman33]

Thanks heyok.

 

[bshaw95]

Does anyone know if the hey ok two position controller will work? I run a dx3s and only have one two position switch.

 

[heyok]

Does anyone know if the hey ok two position controller will work? I run a dx3s and only have one two position switch.

Yes, it will work!