New RR10 Bomber, Savox 1230 install tips

[Jettcity1]

Its basically a brand new RR10 Bomber, I am ready to install the Savox 1230 Servo and I'd like a few tips. Yes, there are many very tiny little allen head button-head screws that may need to come off (Roll cage removal) or can I do it through the bottom of the rig?
I need to get more tiny allen wrenches, a 1/4 drive or nut runner type handle is needed for this rig.
Just the basics, what is the easiest and quickest way to install the new steering servo?
I looked on YouTube but didn't see a specific step-by-step process and the Axial manual doesn't have much other than some nice pictures, graphics and views.
Thanks in advance.

 

[Jboucher]

You need a set of hex screwdrivers, 1.5mm, 2mm and 2.5mm and then a set of socket drivers 4mm and 7mm at least.
These will be very useful for ALL RC trucks basically.

For the servo, you might be able to install it through the front area but then you need to connect the wire to the receiver anyway so... Open up the whole thing...

Should be 6 screws for the cage (3 on each side) then 2 screws under the cage in front of the receiver box

Once it's opened, it's a easier to manage. There should be 4 screws for the servo plus the wire going to the receiver box.

Sent from my Pixel 2 XL using Tapatalk

 

[colbynobo]

For me, it's been the screws on the side of the skidplate, 2 screws on the front of the cage which point down and are just behind the servo, and then I remove either the top set-screws or the bottom button head screw holding on each of the shocks. That allows me to pop the whole cage off and get to the entrails.

 

[Jboucher]

Yeah I forgot the shocks, you need to remove the top screws or bottom screws.

Sent from my Pixel 2 XL using Tapatalk