andymac0035
Pebble Pounder
So after 4 years my stock AE-5 finally gave up the magic smoke. I bought a hobbywing 1080 for my SCX10 and about 30 seconds into running it my RX died (as in fried). This was the original tactic radio and it's seen a lot of use so I wrote it off. I had another identical rx/tx in another truck I'm not using so I put that one in it. 30 seconds into a run that one fried too. I've got a traxxas RX/TX in it now and it seems okay so far.
This is an OG SCX10 that is fairly stock running 3S, motor is stock 27t and servo is a cheap 200oz I've been running for years. No external bec either. This is the set up I've been running for the last 4 years. I checked the program card and the internal BEC is set for 6V (if it had been on 7.2v this might make sense). I looked at the specs for the rx online and it's rated up to 7v so running them with 6v should not be frying them.
So I'm down 2 radio's because of this esc and I'm not too happy about it. I got it from an ebay seller and am contemplating what I should do. It just seems like the esc has a problem with some receivers.
Thoughts?
This is an OG SCX10 that is fairly stock running 3S, motor is stock 27t and servo is a cheap 200oz I've been running for years. No external bec either. This is the set up I've been running for the last 4 years. I checked the program card and the internal BEC is set for 6V (if it had been on 7.2v this might make sense). I looked at the specs for the rx online and it's rated up to 7v so running them with 6v should not be frying them.
So I'm down 2 radio's because of this esc and I'm not too happy about it. I got it from an ebay seller and am contemplating what I should do. It just seems like the esc has a problem with some receivers.
Thoughts?
