Hobbywing 1080 calibration issue

[bezzy300472]

Hi all. I have an issue setting up my 1080,s on my Bully 2 I have 1 esc per motor. And am running an MT44 tx with 482 RX servo is run directly of ccBec. 1 esc has red wire removed. Both power on fine. Neutrals on TX are default. Front motor esc is in throttle rear motor in aux1. The Esc's both calibrate the neutral position but forward and reverse nothing happens when black button on esc is pressed at a total loss. Any advice is appreciated.

 

[mikemcE]

Hi all. I have an issue setting up my 1080,s on my Bully 2 I have 1 esc per motor. And am running an MT44 tx with 482 RX servo is run directly of ccBec. 1 esc has red wire removed. Both power on fine. Neutrals on TX are default. Front motor esc is in throttle rear motor in aux1. The Esc's both calibrate the neutral position but forward and reverse nothing happens when black button on esc is pressed at a total loss. Any advice is appreciated.

Each ESC has to be calibrated to the throttle first. I found it easier to do both on one channel, then switch the second to your other channel. I had this issue with both the BRMD, and dual 1080’s


Hang up and Drive