dumb LED question

[tomvaillencourt]

I'm sure this will seem like a dumb question and/or has already been covered elsewhere, but I searched and did not find an answer... I'm running stock receivers in both my wraith and my SCX10. I use the Ch3 slot to power my LED's, but is it possible to power another LED string from the bind port (BAT)?
I just picked up a light bar for my wraith, and really don't want to splice it in. I'm still new to soldering and its a PITA...

 

[mjc597]

Yeah any open channel in your receiver will power lights

 

[tomvaillencourt]

Thanks man.. I was really beginning to hope that wasnt too dumb of a question... 58 views and only one response. hahaha... I didn't want to fry the lights trying to figure it out for myself... appreciate the feedback.

 

[Kingmeow]

You can also make a "squid" cable. Once connector to the Rx and many connectors on the other end. Very similar to parallel charge cables.