• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

battery

  1. Ghost Koi

    Best battery for Axial SCX10 C/R?

    Hey guys, just ordered my first Axial Jeep :D I'm new to the RC Community and I was wondering what the best battery/charger combination would be for the SCX10 Jeep Wrangler Unlimited C/R Edition. I am planning on keeping it stock for now and I would like to maximize the run time of it. Also...
  2. J

    Stock 7.2V Stick Batt, In the Lansu Remote

    just wondering if it is possible to use the stock 7.2v stick battery in the lansu radio. I have seen posts in the past of swapping them in. But do I need to do anything special, or just solder It on. Thanx
  3. S

    winch battery

    I have connected two 350mah 3.6v cordless phone batteries to make 7.2v for my winch power supply lightweight and compact best of all it only cost me $8 on clearance at crappy tire for the pair. Anyone else have cheap tips on batteries.
  4. KanchiX

    Motor/3s Battery Question(s)

    I almost posted this in the Axial Wraith specific section, but realized it belongs here... I purchased a Speed Gems motor tonight and I noticed on their site that it's meant for 3.7-7.4v, I wanted to know if I could use a 11.1v battery provided I'd be running it through an external BEC. Would I...
  5. T

    Help matching electrics? Battery, Motor, ESC

    Hello all, I have built the Axial Dingo kit and I’m ready to buy electronics. I have a few questions that I hope someone can help answer. I’m looking at doing this on the cheap and upgrading to a rebuild-able motor later. I'm thinking of the Outcry Crawler Single Motor ESC (Part Number...
  6. C

    SR3000 RX on Losi MRC - wiring ?

    Hi all, i recently got a Losi MRC, used, with 4 wheel-steering (stock Losi radio for now). I have a Spektrum DX3.0 and SR3000 receiver, so i figure there should be a way to wire it so that i can take advantage of the 3 channels to run the rear steering separate. why? i dont know yet, because i...
  7. D

    crawler king esc

    Does anybody know if the stock crawler king with handle 7.4 volt lipo
  8. S

    Lookin for new battery

    I am running the rx280 motor an want a battery pack to give me the longest run time I do not care about comp specs win I run the factory nmh the run time is 2-3 min I hade the losi lipo they say the truck calls for but it dise not seem to b putting out anymore is there a better battery or should...
  9. S

    wraith carnage

    I got my wraith about 4 months ago and cant stop building and adding to it, my wife thinks im a freak. I have viewed many pics of other wraith rigs and have gotten so many ideas but i try not to copy people because its better when its original. I am manly a basher but the wraith has turned me...
  10. H

    battery position

    Need help! I wanna lower the center of gravity of MRC, thinking about to put the battery on servo or between servo and motor. I need some advices. Thanks a lot.
  11. H

    battery cable problem

    Need help! I am newbie to MRC, first step I wanna do is move battery to front, but I find out the cable is not long enough. What kind of cable I should get? If change the battery to lipo with a EC3 connector, how could I connect to ESC then? Thank you guys very much!
  12. S

    ESC and battery motor questions.

    I am starting to build my wraith and looking at either a ETRONIX PROBE WP BRUSHED ESC w/15T LIMIT or a HPI SC-15WP as the speed control for a Axial 27t motor has any one used these ? Also i am thinking of using a mini battery pack Black Magic 2200mAh 7.4V 30C LiPo has anyone used this battery...
  13. T

    venom creeper battery mount

    Does anyone know of a better battery mount for the creeper to lower the center of gravity. Im just using a 4500mah nimh battery and want to put it some were else because it flips over to easy. thanks.
  14. B

    2S Lipo for Wraith Question

    Hi everyone I ordered an Axial Wraith recently and am looking forward to 2S LiPo suggestion. Is it a good idea to use this battery: Turnigy nano-tech 5300mah 2S2P 50~100C Hardcase Lipo Pack HobbyKing R/C Hobby Store : Turnigy nano-tech 5300mah 2S2P 50~100C Hardcase Lipo Pack I am a bit...
  15. C

    Lack of torque. Is it the motor or battery?

    Hey guys I'm new to crawling so I'm not sure what is happening. I just got a holmes 35t motor and installed it. Every now and then when crawling it seems to die, esp. when stuck in a tight spot that requires alot of torque. The wheels will stop spinning as if there is not enough torque to...
  16. S

    Please verify that I'm not killing my LiPo batteries

    I'm new to R/C ground vehicles and LiPo batteries. I have the following: Thunder T-610 charger 2 x Gens Ace 2-cell 7.4V 30C 5300 mAh batteries I've put each battery through about 4 cycles each with no issues. However, I was just charging one of the batteries when I noticed that even though I...
  17. S

    Verify that I bought the right stuff?

    I'm brand new to R/C ground vehicles, and battery R/C in general. Can you guys verify that I just bought the right stuff for my first endeavor? Here is what I have coming: 1 Axial Wraith RTR 2 Gens ace 5300mah 2S 1P 7.4V 30C Lipo battery packs 1 Thunder G350 Power Supply 1 Thunder T610...
  18. M

    Losi Trail Trekker Battery Life and Upgrade

    I just bought a Trail Trekker, and I love it (while it lasts). Being new to rock crawlers, I wasn't sure what to expect for the "extra long run times" promised on Losi's web site for the stock 4.8V 220mAh battery. I'd read elsewhere you can expect at most 20 minutes of run time... I'm getting...
  19. G

    Need help with some electronics.

    im rockin a rooster crawler brushed with a Low Bucks Racing 55T Dual Ball Bearing Brushed Motor in my scx10 with the stock pinion (20) and the stock trans spur (87) and it barely goes faster than walking speed. i would like as much torque as i can reasonable get while still having enough wheel...
  20. J

    Losi Mini Crawler Pro Help Please

    Hi guys I'm kinda new to crawling but my first crawler is the losi mini crawler pro and im having a fair bit of battery confusion...i don't realy have money for a new esc so i took the Tamiya TEU101BK esc off my tamiya tt01 for the crawler. Now here is the problem i don't really know if the esc...
Back
Top