Hondarider94
Pebble Pounder
Compared to regular scx10 straight axles - how much lower is the gear ratio in these?
and are these more wide than regular scx10 axles
and are these more wide than regular scx10 axles
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
portal gear ratio
- Thread starter Hondarider94
- Start date
DRED805
Rock Crawler
Stock, the portal gears alone drop it an extra 1.92:1 (12/23 portal gears)... There's lots of gearing options, though.
I'm using a D44 (vs4-10/scx10 ii) front and scx10 iii portal rear. Underdrive diff gears in the front, and 14/21 OD portal gears in the back brings it to roughly the 30% OD range, overall.
The widths aren't noticeably different, but I just threw a tape on it. The scx10 iii Axle is about 1/4" wider than the D44.
Hondarider94
Pebble Pounder
ahh so 2 different axles on the rig lol
