my Hobbywing 1080 esc is beeping when driving

[pimaizumi]

Hi !


I am a crawler beginner !
I calibrated the esc according the instructions and everything went as expected.


It works fine to drive , but the led flashes red and make some beeps while driving fwd and reverse , is that normal behaviour ? or do I have an issue ?

I am using a brushed motor and a 7.2v nimh acc

 

[xagoras]

Is it set to NiMh or Lipo mode? Check setting 2 on the card, it should be 2-2

If that's OK, then check your throttle trim. Might need to lower it a bit.

 

[Voodoobrew]

It should be set crawler reverse for crawlers. Otherwise reverse is not instant. But I don't think it will beep in just fwd/reverse mode. The red just means it's receiving a reverse signal usualy.

Sent from my SM-N986U using Tapatalk

 

[pimaizumi]

Thanks for the answers !

I had it set to 2-2 already , but playing around with the throttle trim solved the beep "thumbsup"