I modified a 1.55 "glue on" I found on Thingiverse and turned it into a face for a 1.7 three piece beadlock. https://www.thingiverse.com/thing:4944090
Using a different 1.9 beadlock I found (https://www.thingiverse.com/thing:4961434) that I didn't like the look of, I resized the rear half and clamp ring but I didn't like how wide the offset was.
These are the custom fount halves mounted on the rear of an RC4WD 1.7 wagon wheel with 1.7 Patigonia tires.
Would anybody be interested in me putting these on Thingiverse? For the record, I'm very new to CAD, these are far from perfect but I'm happy enough with how they turned out I wanted to share. When I have the time to fiddle with them some more, I want to sink them back down to 1.55 (I only had 1.7 tires available)
Sent from my LM-V600 using Tapatalk
Using a different 1.9 beadlock I found (https://www.thingiverse.com/thing:4961434) that I didn't like the look of, I resized the rear half and clamp ring but I didn't like how wide the offset was.
These are the custom fount halves mounted on the rear of an RC4WD 1.7 wagon wheel with 1.7 Patigonia tires.
Would anybody be interested in me putting these on Thingiverse? For the record, I'm very new to CAD, these are far from perfect but I'm happy enough with how they turned out I wanted to share. When I have the time to fiddle with them some more, I want to sink them back down to 1.55 (I only had 1.7 tires available)
Sent from my LM-V600 using Tapatalk
Last edited:
