anarchyinc
Newbie
Iv been piecing together a brushless moa over the last several years and the finish line is in sight!
But need a little help with the power source.
2x Tekin RX4
2X Tekin roc 412 3100KV
Can I run 2 esc's off one batt?
If so what kind of discharge rate should I be looking at?
I would asssume by hooking up 2 esc/motors to one batt would theoretically cut my mAH and C ratings in half?
I used to have a Summit and a hopped up revo several years back I ran with Lipo a few years back, Im not a complete worm when it comes to these lipos, but I do prefer my Nitro!!!
Thanks
J
But need a little help with the power source.
2x Tekin RX4
2X Tekin roc 412 3100KV
Can I run 2 esc's off one batt?
If so what kind of discharge rate should I be looking at?
I would asssume by hooking up 2 esc/motors to one batt would theoretically cut my mAH and C ratings in half?
I used to have a Summit and a hopped up revo several years back I ran with Lipo a few years back, Im not a complete worm when it comes to these lipos, but I do prefer my Nitro!!!
Thanks
J