Catle Mamba Micro X Sensor connector pin types?

[stimpy]

Hey up,

So my Mamba Micro has the adapter cable then a regular 6 pin sensor lead but I want to make a new lead up direct from the MMX to the motor.

Does anyone know what the connector type or the pins size / type for the MMX end are?

Thanks...

 

[HumboldtEF]

Holmes Hobbies has those sensor wires in 5" and 10" lengths. I'm not sure it that helps or not.

https://holmeshobbies.com/sensor-wire-10-5-for-castle-mamba-x-series.html

 

[stimpy]

Holmes Hobbies has those sensor wires in 5" and 10" lengths. I'm not sure it that helps or not.

https://holmeshobbies.com/sensor-wire-10-5-for-castle-mamba-x-series.html

Thanks, I had seen those but I want something around 2.5/3" long hence If I can get some pins then I'll make my own one "thumbsup"

 

[robert@castle]

It is a 2mm pitch header. Fairly certain this is a compatible part.
https://www.mouser.com/ProductDetail/Harwin/M22-3010600?qs=ulE8k0yEMYYsWdFlNtQPXA==
https://www.mouser.com/ProductDetail/Harwin/M22-3050042?qs=PwIzhSyAwqNONKVgowhP1w==

 

[stimpy]

It is a 2mm pitch header. Fairly certain this is a compatible part.
https://www.mouser.com/ProductDetail/Harwin/M22-3010600?qs=ulE8k0yEMYYsWdFlNtQPXA==
https://www.mouser.com/ProductDetail/Harwin/M22-3050042?qs=PwIzhSyAwqNONKVgowhP1w==

Thanks Robert.

Sadly £12 shipping to the UK for £1.27 of goods! haha...

I shall try find something in the UK perhaps..