• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

wiring

  1. C

    PVC vs Silicone Wiring?

    Hello everyone, first ever post on this forum. I have rolls of 14awg pvc wiring sitting in my garage. Would it be okay to use pvc instead of silicone? I've read that silicone has a higher temperature range though.
  2. C

    SR3000 RX on Losi MRC - wiring ?

    Hi all, i recently got a Losi MRC, used, with 4 wheel-steering (stock Losi radio for now). I have a Spektrum DX3.0 and SR3000 receiver, so i figure there should be a way to wire it so that i can take advantage of the 3 channels to run the rear steering separate. why? i dont know yet, because i...
  3. R

    Hitech 7954sh question

    Hey crawlers recently purchased a hitech 7954sh and it says its rated for 6V or 7.4V i understand you can hook this too battery power but i use lipo and its only increments of 4.2v? So the next one up is 8.4 too much voltage:/.... Can someone explain what and how i need too wire this? If all...
  4. heyok

    How to wire LEDs

    This will show you how to wire some LEDs to light add some light to your rig. Two bright red LEDs are going to be wired to a plug that you can connect to your receiver to power them up. The plan is to end up with a servo plug going to a length of wire to an LED, then another length of wire to...
  5. T

    *****esc Crimping*****

    Hey guys. Is it safe to crimp wires onto a motor with soldering on the bit that the wire goes into Because my local hobby store says its not safe but i crimped it on and it seemed to work fine. Thanks, Tom
  6. SoddyCrawler

    BEC wiring mixed results???

    I have searched and searched again!! I have searched the forums about BEC wiring with mixed results. I am wanting to know the latest info out there. Here is what I am looking at.... 1 Tekin FXR Castle BEC Hitec 7955 TG Punk Dig 3s lipo 11.1v Spektrum sr3000 rx(3channels plus bind port) My...
  7. R

    How to Wire Up Integy V12 35T Lathe Motor

    Just got an integy 35t motor, and i was wondering how to wire it up. I see see 4 terminals (2 on + side and 2 on - side) on the end of the motor. Which terminals to I attach the wires to?
  8. pixelnate

    Major twichiness after installing CC BEC

    I installed the BEC just as the included diagram showed: Pull the red wire from the ESC, solder BEC leads to ESC leads at the battery terminals, plug the BEC into the receiver. Everything just as the diagram showed. When I put everything back together and connected the battery things went a...
Back
Top