• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

voltage

  1. R

    Weird battery behavior (first time this happened to me)

    Hi everyone, I have two Tattu 4S LiPos (1800 mAh 14.8 V 120C) that is behaving normally, minus one - not irrelevant - detail. I had charged it a day ago to use it as backup in my trail run, but ended up not using it. I connected it yesterday to my iMars D300 charger, it showed as fully...
    • Reezo
    • Thread
    • battery drop lipo storage voltage weird
    • Replies: 11
    • Forum: Electronics
  2. M

    FlySky BS6 Receiver voltage on TRX-4

    Hey everyone, I recently decided to put an old hobbywing ezrun brushless system in my TRX-4, out of an older car from back before everyone used 2.4Ghz and instead had crystals in their transmitter and receiver. What I didn't realize when I did this is that those old esc's put more than the...
    • Mundy64
    • Thread
    • esc receiver trx 4 trx4 voltage
    • Replies: 11
    • Forum: Electronics
  3. J

    Voltage specs for AE-4 Vanguard ESC

    What is the lowest operating voltage of this ESC? The input is wired in series and I see specs saying the ESC is good to 6S. So this means using 2 - 3S packs to get the 6S rating? What about using 2 - 1S packs with huge capacities and running slower and longer?
  4. pingpaul

    Motor - 3500kv vs 3800kv

    Hi, I'm building my first kit, Yeti 1/10 and learning about electronic specs which is fun and I wonder if someone could explain is there a difference between a motor that is 3500kv vs 3800kv? I might start with a 2s lipo and switch to 3s if it's too slow for me. From what I've read and...
  5. J

    Nylint 1/6 Crawler Battery Issue

    I have a 1/6 Nylint Rock Crawler that I recently started messing around with again. So it was just lurching forward, then stopping, then lurching forward, etc., then it stopped really doing anything, just a slight whine from the electronics. I've always read that this means the battery is dead...
    • JonathanS
    • Thread
    • battery issue lurching nylint recondition voltage
    • Replies: 6
    • Forum: Electronics
  6. M

    Servo, Voltage and size

    Hi everyone I hope that it is ok for me to open a new thread, but this is something I feel is sort of specific and not really something I could search for. I am still new in the crawler world, so my budget is very limited. My AX10 RTC is still stock, and one area where I really feel changes are...
Back
Top