• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

steering problem

  1. S

    Wraith Steering Problems

    I was driving my first generation Wraith and rolled it (no worse than usual). Now it won't turn right while the front wheels are on the ground. It turns right fine though. It has the stock Axial AS-2 steering servo. Is there something I can do to fix it? Or should I just buy a new one? Thank you.
    • Slider24
    • Thread
    • steering issue steering problem steering servo wraith
    • Replies: 14
    • Forum: Electronics
  2. Z

    Steering return to center slowly (barely)

    I have a Rockslide RS10 XT that we have been hobbying around with for a while. I can't pinpoint when it happened because my son uses it most, but when we steer the wheels do not center when you let go of (or center manually) the wheel on the controler. I read a bit around here and replaced my...
  3. M

    Spectrum dx4c steering problem

    I have just bought a 5ive t and it came with a dx4c radio and I noticed the steering doesn't turn very far at all in one direction and not far enough in the other spent too long trying trying to adjust everything in the car and everything I could think of in the remote like travel and centering...
    • millfab313
    • Thread
    • dx4c end point spectrum steering problem travel
    • Replies: 3
    • Forum: Electronics
  4. N

    super bully keeps bending steering

    Hi Everyone, I hope this is the right place for this question. I am using a set of super bullies (un-modified) and I keep bending the long bolt on my rear steering sending the rig into a crab-walk, and making the rear steer useless. The bolt I am having issues with is seen in the red circle...
  5. L

    Scx10 w/T-Rex 60 axles...CMS possible?

    So as the title states, I would like to run cms on my setup. I had the hand bros kit on with the stock axles but in switching to the 60's have lost the compatability of the kit. I have done some searching with no avail. Does anyone know of any other options besides me having to make one? Is...
Back
Top