• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

savox

  1. S

    Looking for help understanding external BEC’s and why I need one

    Hello everyone! My SCX10II build is almost complete and with that it’s about time to start installing electronics (the most foreign part to me). For a frame of reference here are the electronics I’m working with: Hobby Wing 1080 ESC Castle Creations 10 Amp BEC Savox 1210SG servo (7.4v...
  2. O

    running extra battery instead of BEC

    Hi ; stock servo died last time , i have another Savox 1210sg that i would prefer to run @ 7.4v i dont own a BEC for the time being , i will run the servo temporary on 2S lipo until i get the BEC. the bronco run 3S lipo , i use holmes BEC connection and noticed that ground/black wire is...
  3. O

    3A BEC for Savox 1210SG

    Hello there; i am new to crawlers and recently got my TRX4 Kit built and add Bronco Body to it. Noticed the weak stock servo immediately and ordered Savox 1210SG WP. heared a lot about Stock traxxas ESC won't handle that Servo my question is will a 3A UBEC from hobbywing is sufficient to run...
  4. S

    Steering Servo Wire Problem

    Newbie here "thumbsup" This is my RTR Bomber. So I bought a waterproof servo so I can run it really good on water and mud as well. Upon installation, I came across this problem. The wire is too short and I wanted to route the wire through the silicone gasket inside the waterproof receiver box...
  5. W

    DX4C and the Servo causing loss of connection.

    So I have a DX4C. I have 3 servos now that seem to be causing this problem I am having. When the Servo is plugged in and used, ie turn the wheels, the DX4C looses connection with the receiver and has to reconnect. I do have a Castle BEC plugged. Once I unplugged the servo everything works...
    • w0pgk
    • Thread
    • connection disconnect dx4c savox servo
    • Replies: 11
    • Forum: Electronics
  6. G

    Savox 1230sg wraith fit?? Bec with mmp??

    I just finished a wraith kit. Mmp, tekin redline 13.5t sensored, a tone of custom wiring, forward battery,... Ect. I used a hitec 5645mg broke it twice,645mg and broke it. Question: I want to get a savox 1230sg but will it fit on my wraith axle mount? Can I run it with internal bec on mmp...
  7. cybertech

    Savox sv1270tg issues

    I just purchased a new Savox 1270 servo for my XR10. After hooking it up I ran 2 packs with it and on my second pack the steering stopped. I have forward and reverse and power to the servo but when I turn the wheel the servo will not. I put a fully charged pack in it and still nothing. I had...
  8. H

    Savox 1256tg servo issues. Winch in/out, lights flicker ??

    I've got a Savox 1256tg servo in my 1.9 scaler and it has started acting very strange. I'm running a Castle BEC (set at 7v due to all of my LEDs/winch) that is running the RX. The powertrain is a MMP with a ROC412 on 3S. The winch controller is a Heyok 2 pos controller. At first, after about...
    • Hoosierdady
    • Thread
    • crap i gotta buy a servo flicker issue savox winch
    • Replies: 3
    • Forum: Electronics
  9. N

    savox sc1232sg servo waterproof?

    i just picked up and installed a new savox servo (sc1232sg) on my wraith and its not advertised as waterproof but was wondering if it was infact waterproof or water resistant, anyone submerged this servo?
    • Nemo
    • Thread
    • savox servo waterproof wraith
    • Replies: 4
    • Forum: Electronics
  10. B

    Reversed steering??

    First of all, yes, I have looked and looked before I started this thread. I'm *NEW* to RC's and don't know jack about them. So don't hate. I replaced my stock wraith's steering servo, with a digital Savox SA-1230 SG. I was careful to note which way the factory servo was plugged in and plugged...
  11. J

    Savox SW-0231MG servo install

    Hello, I'm new to hobby RCs and building my first kit, the Axial SCX10 Jeep Rubicon. I am attempting to use mostly waterproof electronics and wound up buying the Savox SW-0231MG servo. Some sites describe it as a "tall" servo, and the dimensions do seem larger than most. The result during my...
    • jsome
    • Thread
    • savox scx10 steering linkage sw-0231mg
    • Replies: 4
    • Forum: Axial SCX-10
  12. C

    Steering Servo and Rod question

    I have a Savox (1238 I think) and I have adjusted the steering horn to allow for the best possible and equal turning and caster, but when I turn all the way to the right it seems as if my servo locks out and it won't turn the wheels back from the far right locked out position without some...
  13. R

    My Ridgecrest

    I'm new to all of this, but after watching a few djmedic2008 YouTube videos, I got hooked. So, I went with Axial's Ridgecrest! Here's my Ridgecrest with a new chassis from Hot-Racing Parts list: -Savox SC-1258TG -HR Chubs and Knuckles -HR Steering Linkage -HR Front Universal Rock Crawler CVD...
  14. T

    ****best servo fpr mt****

    Hey guys Whats the best servo for a 1/8 scale monster truck. The brand is thundertiger mt4 g3. The truck has really big wheels and tires and i was looking around for a new servo and i would really like to have a servo that has fairly quick speed and loads of tourqe. My prics rang is $100
Back
Top