• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

ratio

  1. D

    Hot motor pinion gearing

    I'm pretty new, but do understand a bit of teching, I'm used to 1/8 buggies. I got myself a RTR Absima Khamba, but I've got the feeling it has a very low ratio (pretty high top speed). The motor gets hot quick, and since I've got heavier tires & rims I especially want to lower the pinion. It...
  2. O

    high clearence reduction knuckles

    ax10 scx10 axial I currently have 3racing high clearence knuckles set of four (reverse Direction of drive)the ratio is 10teeth at 15(2/3) integy makes some sold in sets of two and i was wondering if anyone knows the gear ratio inside them. The reason id like to know is cause im working on...
  3. X

    Need some dimensions of the lcc trans.

    Hello wondering is some one here would be able to take a few measurements to help me out with a project i'm considering using the lcc transmission with. Measurements im looking for 1 Height from top of skid were the trans sits to the center of the output shafts 2 Diameter if the output shafts...
Back
Top