• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

problems

  1. H

    Steering servo twitchy, RX or TX problem?

    heya Crawlers! Long time lurker first time poster here with a problem I need to pick your brains on before i go out and spend more money on new parts. I just got a used Axial SCx24 and the steering servo "sometimes" twitches over to one side when I turn my TX dial/steering wheel. The...
    • Hawk3ye
    • Thread
    • problems receiver servo transmitter
    • Replies: 1
    • Forum: Electronics
  2. N

    Problems to my Axial SCX10

    Hello everyone, my axial has a couple of little problems: when you turn the steering wheel just goes and no gas (sometimes), when you go around turns off and you have to turn it on, the engine after a while you use it warms up so much and the smell of clutch, and when running does not go much...
  3. 1

    Ae-2 esc or reciever problem

    hi, i have a AE-2 esc and a wraith reciever and i was rock crawling and it shut off. and i cant get it to turn back on, no lights, no sound, no nuthin. please help!:roll:
    • 17mrman
    • Thread
    • axial wraith esc help! problems receiver
    • Replies: 2
    • Forum: Electronics
  4. C

    Ridgecrest Problem

    I have a stock ridgecrest with only about an hour on it. I have lost the front wheel drive. I don't know what to start with to try an fix it.
  5. R

    problems on a scx 10 with gmade axles

    Hello. I got a problem with my scx, i mounted the gmade axles a few weeks ago and they fit at the first attempt. But when i try the rig in my backyard i saw the rig in rear gear jumps, not too much, but like it has no grip.Anyone can help me? Thanks anyway. P.S. I have a honcho, with stock motor...
  6. N

    Problems with Axial AE-2 esc

    okay so i just turned on my wraith to finish setting up a new motor and when the esc started to beep ( basically saying please turn on the controller) i could barley hear it. i turned it off then back on and it still couldn't hear it. any suggestions why this is happening? it hasnt been water...
  7. J

    Wraith steering linkage problems...

    I got my whole car put together and was giving it a bit of a test run around my house when I noticed that it was not driving straight when I would go forward, it was curving a little to either side ( with no preference to either side, just randomly). I have looked over the whole car and it is...
  8. pixelnate

    Major twichiness after installing CC BEC

    I installed the BEC just as the included diagram showed: Pull the red wire from the ESC, solder BEC leads to ESC leads at the battery terminals, plug the BEC into the receiver. Everything just as the diagram showed. When I put everything back together and connected the battery things went a...
Back
Top