• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.

mini rock crawler

  1. droopmodmrc

    GC3 cantilever mod

    Just posting up a short video of my cantilever setup. "thumbsup" http://www.youtube.com/watch?v=04vfLHcYbWY
  2. droopmodmrc

    GC3 electronics locations

    The GC3 chassis makes mounting electronics much different. I am running the stock esc with a novak external lipo cutoff, so there is a bit of wire mess, but I like where everything is mounted so far. I would like to see any other ideas you guys have for mounting the battery,esc,servo(bta),shock...
  3. droopmodmrc

    GC3 purple anodized metalcast

    Just got my new chassis. Let me know what you think. This stuff worked great. Takes 7 days to cure fully, but is dry to the touch in one hour. "thumbsup"
  4. droopmodmrc

    Loose bead locks on rear tires

    I got my rear Bead locks set to just barely pin the tire. I tested and I tightened, and then I tightened some more. Now I got it set perfect so the rears just slip right before a forced roll over from the usual rear traction bite .and when you get jammed up it acts very much like a dig. some one...
  5. droopmodmrc

    What to break next ?

    So here is my setup... Flat irons cut'n'shut and butchered proline titus beadlocks integy bent lower links losi threaded alum shocks custom 4 link front and rear losi frenzy 370 motor (modded motor mounting plate to fit motor ) venom 2s lipos 1320 mah 20c burst and a small 430 mah 30 c burst...
Back
Top