• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.
Prev
Mounted and ready. I used my drill press as a lathe to cut the .360 section out of the wheels. the tooling end is just a sharp Harbor Freight pick and
Next
Prev
.360 section cut from stock wheel.
Both cuts done. Rear bead lock was cut using a hand saw and then debured with a grinder.
First cut. The lower section is cut off of the first wheel.
Mounted and ready. I used my drill press as a lathe to cut the .360 section out of the wheels. the tooling end is just a sharp Harbor Freight pick and
Stock wheel ready to be cut. 1.360 A 1/2" bolt fits into the hex on the back and can be chucked into the drill so it can be cut.
Next
BLKXJ 96

Mounted and ready. I used my drill press as a lathe to cut the .360 section out of the wheels. the tooling end is just a sharp Harbor Freight pick and

  • Media owner BLKXJ 96
  • Date added

Media information

Album
XR10
Added by
BLKXJ 96
Date added
View count
14
Comment count
1
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top