• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.
Prev
Front view. The steering servo is a Hitec HS-5645MG powered by Castle Creations 10 amp BEC. The steering tie is the Level3 RC aluminum unit. It connec
Next
Prev
Left side view. The tranny and skid plate were flipped. Front lower suspension links are from an old (and never built because of the debut of the Pro)
Right side view. Shocks are stock Pro units inverted and outboarded. Front shocks are filled with Losi 42.5wt oil with MRC RTR silver springs and thre
Rear view. The ESC is no longer mounted on the rear axle plate. The rear axle adapters were replaced with Losi aluminum units. The upper suspension l
Front view. The steering servo is a Hitec HS-5645MG powered by Castle Creations 10 amp BEC. The steering tie is the Level3 RC aluminum unit. It connec
Bottom view. The standard driveshafts were replaced first by the MIP CVD units and now by the RC4WD universal joint units. I'm experimenting with some
Top view. The ESC can be seen in between the side plates in the forward section of the chassis mounted very low on a homemade lexan shelf and servo ta
Side view, motor side. The ESC/motor system is Novak's Mongoose Crawler.
Next
ClovisCrawler

Front view. The steering servo is a Hitec HS-5645MG powered by Castle Creations 10 amp BEC. The steering tie is the Level3 RC aluminum unit. It connec

There are no comments to display.

Media information

Album
Details of my MRC Pro
Added by
ClovisCrawler
Date added
View count
14
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top