• Welcome to RCCrawler Forums.

    It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!

    Already a member? Login at the top of this page to stop seeing this message.
Prev
2 speed trans was missing shifts. Red arrows show where it was getting worn. Shift servo was set correctly but I wasn't letting off the throttle whe
Next
Prev
Then I ground a flat on the shaft of the bolt and threaded a M3 set screw into the boss in the knuckle carrier AX80106.
I cut the threads and nut off the lower knuckle bolt AX31110.
JConcepts G-Locs on ProLine F11 wheels.
2 speed trans was missing shifts. Red arrows show where it was getting worn. Shift servo was set correctly but I wasn't letting off the throttle whe
ProLine Sand Paw 2.2 tires on front on stock RTR rims. ProLine Sand Paw 3.8" on rear on ProLine F11 wheels. Stock RTR tire/wheel in the middle.
Castle BEC mounted. Siliconed the ends to water proof, mounted with hot melt glue.
Next
gman350

2 speed trans was missing shifts. Red arrows show where it was getting worn. Shift servo was set correctly but I wasn't letting off the throttle whe

  • Media owner gman350
  • Date added
There are no comments to display.

Media information

Album
Axial Yeti RTR
Added by
gman350
Date added
View count
33
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top